Bruiz: Página creada con «To return to the DHCP configuration, you must undo the previously indicated changes: change the drop-down menu from '''Manual to Automatic (DHCP)''' and delete the assigned static IP by clicking on the "'''-'''" button. Dynamic IP address configuration (DHCP). After following the previous steps, you can disconnect the ''kiBox'' from the computer and connect it to the installation's router or switch…»

2024-05-07T07:32:16Z

Página creada con «To return to the DHCP configuration, you must undo the previously indicated changes: change the drop-down menu from '''Manual to Automatic (DHCP)''' and delete the assigned static IP by clicking on the "'''-'''" button. center|imagethumbnail|550x550px|Dynamic IP address configuration (DHCP). After following the previous steps, you can disconnect the ''kiBox'' from the computer and connect it to the installation's router or switch…»

Página nueva

To return to the DHCP configuration, you must undo the previously indicated changes: change the drop-down menu from '''Manual to Automatic (DHCP)''' and delete the assigned static IP by clicking on the "'''-'''" button.
[[File:ES kiAdmin eth0 IPv4 DHCP.png|center|imagethumbnail|550x550px|Dynamic IP address configuration (DHCP).]]
After following the previous steps, you can disconnect the ''kiBox'' from the computer and connect it to the installation's router or switch. You can check that everything has gone well by following the following steps:
# Connect the ''kiBox'' to the router
# Connect the PC to the same router as the ''kiBox''
# Access the ''kiAdmin'' interface through the IP that was configured in the ''kiBox''.
This diagram shows the example of the previous case.
[[File:ES kiAdmin PC-KIBOX Configured.jpg|center|image thumbnail|800x800px|Connection to access the kiBox through the static IP already configured.]]

Translations:KiAdmin/12/en - Historial de revisiones