Bruiz: Página creada con «This tab, as its name indicates, is used to make Modbus requests, either locally or remotely. First, you must configure the communication parameters: *If connecting locally: RTU: port (see “Device Manager” for correct one), Modbus address, speed, data bits, parity type and number of stop bits. TCP: IP address and port. File:KiParameter…»

2024-05-07T07:02:49Z

Página creada con «This tab, as its name indicates, is used to make Modbus requests, either locally or remotely. First, you must configure the communication parameters: *If connecting locally: ** RTU: port (see “Device Manager” for correct one), Modbus address, speed, data bits, parity type and number of stop bits. ** TCP: IP address and port. <gallery perrow="2" widths="400" heights="200" caption="Configuring a Modbus test locally using RTU (left) or TCP (right)."> File:KiParameter…»

Página nueva

This tab, as its name indicates, is used to make Modbus requests, either locally or remotely. First, you must configure the communication parameters:
*If connecting locally:
** RTU: port (see “Device Manager” for correct one), Modbus address, speed, data bits, parity type and number of stop bits.
** TCP: IP address and port.
<gallery perrow="2" widths="400" heights="200" caption="Configuring a Modbus test locally using RTU (left) or TCP (right).">
File:KiParameters - Test Modbus Local RTU.png
File:KiParameters - Test Modbus Local TCP.png
</gallery>
*Through kiconex, select the facility and for:
** RTU: The port index and Modbus address.
** TCP: IP address and port.
<gallery widths="400" heights="200" perrow="2" caption="Configuring a Modbus test remotely using RTU (left) or TCP (right).">
File:KiParameters - Test Modbus kiconex RTU.png
File:KiParameters - Test Modbus kiconex TCP.png
</gallery>
Then, configure the request: Modbus register where the query starts, number of registers to query and Modbus function to be used. If the function is a write function, the “Value” field will be enabled to indicate the value to be written.
<gallery widths="400" heights="200" perrow="2" caption="Configuration of a Modbus test remotely via RTU (left) or TCP (right).">
File:KiParameters - Test Modbus Read Request.png
File:KiParameters - Test Modbus Write Request.png
</gallery>
Once the request is ready, click send. If everything went well, the response will be displayed in different formats. Otherwise, it will show that there has been an error in the reading.
[[File:KiParameters - Test Modbus Response.png|center|frame]]

Translations:KiParameters/147/en - Historial de revisiones