Translations:CONN kiBox/8/en
De wiki.kiconex
2.-Network-internet connection
To connect to the internet, the kiBox must be connected via an RJ45 cable to the connector located at the bottom left. The kiBox connects to the internet via dynamic IP (DHCP). This link shows how to access the kiAdmin to modify your network configuration and set a static IP.
3.-Power supply connection
To power the kiBox a 3-wire hose is required. The wires would be connected to terminals as indicated on the terminal block. The voltage range must be between 88 and 264V AC. With a mains frequency between 47-63Hz. It is important to correctly connect the power supply ground as this will be used to shield the cables connected to the modbus ports.
